[time-nuts] Lucent KS-24361 J6 connector

Bob Camp kb8tq at n1k.org
Mon Nov 17 12:07:18 EST 2014


Ok, that’s very cool !!!!

If you can hit all the SCPI stuff *and* the PPS on the one connector, there is no need to wire to the DIAG port at all.



> On Nov 17, 2014, at 11:55 AM, Götz Romahn <goetz at g-romahn.de> wrote:
> read this on:
> http://www.realhamradio.com/gps-satstat-software.htm
> When you first turn on the Z3816A GPS receiver, it is always continuously sending time. There are two commands you need to use: one to put it into the SCPI> command mode, the other to switch it back to sending time. The two commands are:
> To go to the SCPI mode:
> ptim:tcod:cont 0
> To go to the continuous time mode:
> ptim:tcod:cont 1
> this holds true also on the J6 (RS422/1PPS) connector of the Lucent KS-24361 Z3811 and maybe Z3812 ( watchout there is no !! echo if you are using a terminal software but Z3811.exe works fine).
> cheers Götz
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.

More information about the time-nuts mailing list