[time-nuts] Lucent KS-24361, HP/Symmetricom Z3809A, Z3810A, Z3811A, Z3812A GPSDO system
Mike Seguin
n1jez at burlingtontelecom.net
Fri Oct 31 12:19:26 EDT 2014
I have both of my units sitting on the bench. I found that I needed to
connect them together to get the REF1 unit to come out of standby.
I am using GPSCon to monitor and it appears to work fine.
One thing on my units, when I power cycled them, it started a 'survey'
over! I didn't expect that. Are others seeing this. There must be a way
to store the surveyed position....
Tnx,
Mike
On 10/30/2014 3:59 PM, Bob Stewart wrote:
> Hi Anthony,
> Did you power cycle both units as part of connecting them together at J5 to J5? And can you remind me whether you are using the supplied interface cable, or are you using something else? After warmup, the ON light is on for the REF-0 unit and the STBY light is on for the REF-1 unit. While running, there is no output from J8 on the unit marked STBY. J8 works on the unit marked ON. There is a timestamp coming from J6, and I think a 1PPS signal on some pin or other.
>
> Bob From: Anthony Roby <aroby at antamy.com>
> To: Discussion of precise time and frequency measurement <time-nuts at febo.com>
> Sent: Thursday, October 30, 2014 2:24 PM
> Subject: Re: [time-nuts] Lucent KS-24361, HP/Symmetricom Z3809A, Z3810A, Z3811A, Z3812A GPSDO system
>
> I'm still having no luck with mine. When I power on, the LEDs cycle, the Fault light is on and the No GPS and Standby lights flash. When I connect my GPS antenna, the No GPS light stops flashing and stays on. After several minutes only the Standby light is on.
>
> When I connect both the Ref1 and Ref0 together with the interface cable, the Fault lights on both units are illuminated.
>
> Do you see the same? I don't know what to infer from the Fault light since there is no supplemental data to work from.
>
> Anthony
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
--
73,
Mike, N1JEZ
"A closed mouth gathers no feet"
More information about the time-nuts
mailing list