[time-nuts] Signal/Phase noise analyzer
Bob Camp
kb8tq at n1k.org
Wed Apr 22 18:36:14 EDT 2015
Hi
Is this for a business or for a basement?
Are you looking for new self contained gear or combinations of used gear?
Is a cross comparison device ok or do you need a stand alone device?
How low do you need to go how fast? Is -190 dbc/ Hz low enough? Is a 24 hour run to long?
Lots of variables….
Bob
> On Apr 22, 2015, at 10:07 AM, Vasco Soares <vesoares at deea.isel.ipl.pt> wrote:
>
> Hi All,
>
>
>
> I'm searching for the less expensive signal analyzer to perform phase noise measurements on OCXO's. There is no need to go above 400 MHz - 1 GHz. I'm particularly interested on low frequency offset and good close in phase noise specs. Any recommendations?
>
>
>
> Best regards,
>
> Vasco Soares
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the time-nuts
mailing list