[time-nuts] Fluke/Gigatronics 6060 series (6062A specifically)output amplitude cal constants

Bill Reed breed at otelco.net
Tue Aug 11 20:32:22 EDT 2015


I have a service manual for the 6080A/AN. The cal procedure may be the same.

Bill Reed

-----Original Message----- 
From: John Ackermann N8UR
Sent: Tuesday, August 11, 2015 6:06 PM
To: Discussion of precise time and frequency measurement
Subject: Re: [time-nuts] Fluke/Gigatronics 6060 series (6062A 
specifically)output amplitude cal constants

I'd be interested in that as well... mine is out of amplitude cal as well.

> On Aug 11, 2015, at 4:23 PM, Richard Moore <richiem5683 at gmail.com> wrote:
>
> Does anyone know the procedure for resetting the output level constants in 
> these generators? The manuals I’ve found are silent on this, but it was 
> obviously done at the factory… Mine needs levelling.
>
> Dick Moore
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to 
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to 
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there. 


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus



More information about the time-nuts mailing list