[time-nuts] 10MHz Square to Sine Wave Conversion

[Alex Pummer]

Charles Wenzel has very simple but good working solution, here is :
  http://www.wenzel.com/documents/waveform.html


  On 7/17/2015 8:20 AM, Richard Solomon wrote:
> I have a Mini-Circuits BLP-10.7 that I picked up at a Flea Market that 
> does the job.
> And no, I do not want to sell it !!
>
> 73, Dick, W1KSZ
>
> On 7/16/2015 10:47 PM, Jason Ball wrote:
>> A would have thought a simple band pass filter would do the job by 
>> tuning
>> out the harmonics.
>>
>> On Fri, Jul 17, 2015 at 3:49 AM, skipp Isaham via time-nuts <
>> time-nuts at febo.com> wrote:
>>
>>> re: 10MHz Square to Sine Wave Conversion
>>>
>>> The GPSDO I recently acquired outputs a 10 MHz square wave. I'd like
>>> to convert it to a sine wave and I am looking for suggestions and 
>>> info re
>>> any reasonable pre-made circuits and/or boards. No sense reinventing 
>>> the
>>> wheel if I can avoid it.
>>>
>>> Otherwise I will start from scratch and make a new wheel....
>>>
>>> Thank you in advance for your replies.
>>>
>>> Regards,
>>>
>>> skipp
>>>
>>> skipp025 at yahoo dot com
>>>
>>> _______________________________________________
>>> time-nuts mailing list -- time-nuts at febo.com
>>> To unsubscribe, go to
>>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>>> and follow the instructions there.
>>>
>>
>>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to 
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.