[time-nuts] Trimble Thunderbolt question, splitting its output.
time at patoka.org
Sun Mar 29 09:52:20 EDT 2015
In my project, I was using LT6957 to share 10Mhz from my TBolt. It was
perfectly fine for my setup. I split 10Mhz to feed the clock of MCU and
second output was connected to DDS block (AD 9852).
On , Chris Wilson wrote:
> 27/03/2015 17:14
> My T/Thunderbolt has operated flawlessly for some years feeding a
> David Partridge frequency divider board. The board gives 10Mhz and
> lower divisions of 10MHz down to the KHz level out, as square waves.
> What I need to know is, can I T off the T/Thunderbolt 10MHz feed to
> this board and take a second sine wave output direct from the
> Thunderbolt, to drive a transceiver GPS disciplined 10 MHz frequency
> standard input as well as having it feed the divider baord, which has
> a square wave output? Thanks.
> The .pdf for David's board is at:
More information about the time-nuts