[time-nuts] Inside a CTS 1960017 OCXO
Rob Sherwood.
rob at nc0b.com
Sat Feb 27 19:44:20 EST 2016
I would have to make the measurement again with the HP supply off.
I have measured my Rubidium and my GPSDO and never seen anything like this spectra of close-spaced spurious.
I'll send you some more data direct.
Rob
NC0B
-----Original Message-----
From: time-nuts [mailto:time-nuts-bounces at febo.com] On Behalf Of Hal Murray
Sent: Saturday, February 27, 2016 3:32 PM
To: Discussion of precise time and frequency measurement
Cc: hmurray at megapathdsl.net
Subject: Re: [time-nuts] Inside a CTS 1960017 OCXO
rob at nc0b.com said:
> I cannot say exactly, as I measured it as 59 Hz. VA7OJ measured it as
> 60 Hz. I was using an HP lab supply, and Adam was using some other lab supply.
> I put a 500 uF capacitor across the Vcc pin and it had no effect. I
> don't think it has anything to do with the power supply since both of
> us saw the same thing. ...
How much line noise is floating around the lab? What does the spectrum analyzer see if you power off the DUT?
--
These are my opinions. I hate spam.
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
--
If this email is spam, report it to
https://support.onlymyemail.com/view/report_spam/ODExMjI6MTg1NzM5OTk5ODpyb2JAbmMwYi5jb206ZGVsaXZlcmVk
More information about the time-nuts
mailing list