[time-nuts] OT stuffing boards: was GPS interface/prototyping board

Oz-in-DFW lists at ozindfw.net
Fri Jun 24 09:45:04 EDT 2016

On 6/23/2016 9:36 PM, Bob Camp wrote:
> Hi
> The gotcha with “really slow” is that once you print the solder paste on the board, it has a very 
> limited “open air” life. If you don’t get the board done fairly quickly, your soldering quality can
> suffer quite a bit.
> Bob
For most of the paste formulations I've had no trouble with several
hours of working time. So you need to get at it, but really don't end up
hurting yourself, but can't leave it overnight. .

mailto:oz at ozindfw.net    
POB 93167 
Southlake, TX 76092 (Near DFW Airport) 

More information about the time-nuts mailing list