[time-nuts] Fw: 5065

Tom Van Baak tvb at LeapSecond.com
Thu Mar 17 12:07:42 EDT 2016


Ulrich,

You can buy the MS connector from Digikey, Mouser, etc. Some practical time-nuts just rip out the expensive mil-spec connector and install a normal IEC connector. Or, if you're brave, just remove the bottom panel and use jumper wires to deliver 120 VAC directly to the pins. But, very important, make sure you've got the right pins.

See http://leapsecond.com/museum/hp5065a/conn.htm for details.

/tvb


----- Original Message ----- 
From: "KA2WEU--- via time-nuts" <time-nuts at febo.com>
To: <time-nuts at febo.com>
Sent: Thursday, March 17, 2016 7:29 AM
Subject: Re: [time-nuts] Fw: 5065


> 
> The HP 5065A Rubidium Frequency Standard requires  a circular 3 pin adapter 
> cable that  can be plugged into 115V AC outlet. 
> I checked all cables I have  and this particular cable  is not finable. Can 
> the unit set to 110/220 V  
> Maybe  this cable can be  purchased  or assembled ?   ULRICH  
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.


More information about the time-nuts mailing list