[time-nuts] high rev isolation amps

Rob Sherwood. rob at nc0b.com
Sat Mar 26 17:30:30 EDT 2016


You cannot add the directivity and gain.  Doesn't work that way.  Rob, NC0B. 

Sent from my iPad

> On Mar 26, 2016, at 2:00 PM, "jimlux" <jimlux at earthlink.net> wrote:
> 
> 
> 
> Consulting the time-nuts hive mind here..
> 
> I'm looking for off the shelf connectorized amplifiers with very good reverse isolation for doing things like intermod measurements (e.g. 2 signal generators followed by amps/pads into a combiner) and phase noise measurements for a digital receiver.
> 
> 1-100 MHz kind of frequency range..
> 
> I've used ZFL-500LN (30dB gain, 27 dB directivity in the data sheet, which I interpret as 57dB reverse) , ZX60-4016 (really more of a microwave amp, and not so hot reverse wise.. 25 dB)
> 
> I'm not particularly cost constrained, so a higher power amp (which also reduces distortion products from the amp) followed by pads is always an alternative.
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
> 
> 
> 
> --
> If this email is spam, report it to
> https://support.onlymyemail.com/view/report_spam/ODExMjI6MTg2NjQ0MTI4Mjpyb2JAbmMwYi5jb206ZGVsaXZlcmVk
> 


More information about the time-nuts mailing list