[time-nuts] high rev isolation amps
Bruce Griffiths
bruce.griffiths at xtra.co.nz
Sat Mar 26 18:25:00 EDT 2016
On Saturday, March 26, 2016 09:30:30 PM Rob Sherwood. wrote:
> You cannot add the directivity and gain. Doesn't work that way. Rob, NC0B.
>
> Sent from my iPad
Minicircuits would disagree with that and its their amplifier.
Bruce
>
> > On Mar 26, 2016, at 2:00 PM, "jimlux" <jimlux at earthlink.net> wrote:
> >
> >
> >
> > Consulting the time-nuts hive mind here..
> >
> > I'm looking for off the shelf connectorized amplifiers with very good
> > reverse isolation for doing things like intermod measurements (e.g. 2
> > signal generators followed by amps/pads into a combiner) and phase noise
> > measurements for a digital receiver.
> >
> > 1-100 MHz kind of frequency range..
> >
> > I've used ZFL-500LN (30dB gain, 27 dB directivity in the data sheet, which
> > I interpret as 57dB reverse) , ZX60-4016 (really more of a microwave amp,
> > and not so hot reverse wise.. 25 dB)
> >
> > I'm not particularly cost constrained, so a higher power amp (which also
> > reduces distortion products from the amp) followed by pads is always an
> > alternative. _______________________________________________
> > time-nuts mailing list -- time-nuts at febo.com
> > To unsubscribe, go to
> > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the
> > instructions there.
> >
> >
> >
> > --
> > If this email is spam, report it to
> > https://support.onlymyemail.com/view/report_spam/ODExMjI6MTg2NjQ0MTI4Mjpyb
> > 2JAbmMwYi5jb206ZGVsaXZlcmVk
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the
> instructions there.
More information about the time-nuts
mailing list