[time-nuts] Thinking outside the box a super reference
bruce.griffiths at xtra.co.nz
Thu Nov 3 18:55:34 EDT 2016
There is at least one recent thesis where a dual resonance rubidium vapor cell was built and used to lock a low noise OCXO,The machining of the cavity didnt appear particularly challenging nor did the locking of the laser to the relevant wavelength using an auxiliary rubidium vapour cell.IIRC thee performance was better than the telecom market rubidium standards.
On Friday, 4 November 2016 11:34 AM, Attila Kinali <attila at kinali.ch> wrote:
On Thu, 3 Nov 2016 16:54:24 -0400
Bob Camp <kb8tq at n1k.org> wrote:
> If you look at a modern CPU as “just a handful of sand and some stuff”, it seems
> pretty easy to build one in the kitchen after an hour or two of setup. When you dig
> into the nasty details the line costs rapidly spiral off into the stratosphere. Atomic
> standards are not quite as complex, but there still is more than just a little custom
> equipment involved. $1M sounds a bit on the low side of what it might take.
Not necessarily. There is a large corpus of knowledge available on
how to build vapor cells standards and what is a good idea and what
isn't. Most of it is documented in papers of the PTTI, EFTF and IFCS.
The former two are freely available (for PTTI until 2010, but that
should be good enough). Getting access to those papers behind a
paywall, you only need to know someone with access to a university.
(not for PTTI post 2010 though, ION has quite anal access rules)
Additionally, the people in the time and frequeny community are very
open to discussion and exchange of knowledge. You can almost always
just walk up to someone and ask questions with a high chance of getting
not only answers but help in how to proceede.
Tapping into this knowhow would avoid the need to try out the whole
solution space and concentrate on the few parts that are unkown or
not well enough understood and optimize those. And by doing so safe
a lot of money.
Any simple idea will be worded in the most complicated way.
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the time-nuts