[time-nuts] How to get PPS from ublox mini-PCI GPS to APU2 SoC serial port for ntpd
albertson.chris at gmail.com
Wed Nov 9 01:40:04 EST 2016
The MAX3223 chip does exactly what you need. It converts 3.3 volt serial
to RS232 levels.
You can buy just the chip and add a few passives to a perf board and make
what you need or buy a little PCB with the parts already soldered down like
It is actually cheaper to buy the little PCB then to buy the parts to make
On Tue, Nov 8, 2016 at 7:23 PM, STR . <strykar at hotmail.com> wrote:
> >The signals on the DB9 connector are at RS232 levels, your GPS module is
> likely 3V3 CMOS, you will need to make a level translator if you wish to
> use a standard PC >RS232 serial port.
> Would this do the trick? - http://www.banggood.com/8-Channel-Logic-Level-
> I'll get some 3.3 and 5 V power supplies too.
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/
> and follow the instructions there.
Redondo Beach, California
More information about the time-nuts