[time-nuts] Thunderbolt Schematic
Richard W. Solomon
w1ksz at earthlink.net
Tue Nov 29 22:45:39 EST 2016
Thanks much, I'll see how it looks tomorrow.
73 es HH, Dick, W1KSZ
-----Original Message-----
From: time-nuts [mailto:time-nuts-bounces at febo.com] On Behalf Of EB4APL
Sent: Tuesday, November 29, 2016 7:46 PM
To: Discussion of precise time and frequency measurement
Subject: Re: [time-nuts] Thunderbolt Schematic
Hi,
I have a cousin of the Thunderbolt, The Trimble Nortel NTGS50AA.
I have a partial schematic that includes the 10 MHz output circuit that I will attach in the hope it can be done. Hopefully both have something similar.
Regards,
Ignacio, EB4APL
El 30/11/2016 a las 2:30, Scott Stobbe escribió:
> If the unit is low on amplitude, there isn't likely much more than a
> buffer amp between the ocxo and 10 MHz output.
>
> On Tue, Nov 29, 2016 at 7:54 PM Bob Camp <kb8tq at n1k.org> wrote:
>
>> Hi
>>
>> There is no schematic for the TBolt available. Based on Trimble’s
>> approach to keeping all their IP private (look at the survey side …),
>> there will not be a schematic coming out from them. Since a good
>> chunk of the functionality is in the FPGA’s and CPU’s, a schematic
>> may be a tough thing to come up with by tracing this and that on the board.
>>
>> Bob
>>
>>> On Nov 29, 2016, at 6:38 PM, Richard W. Solomon
>>> <w1ksz at earthlink.net>
>> wrote:
>>> From the last e-mail I saw in 2014, there was no schematic available.
>>>
>>>
>>>
>>> Has anything changed lately, is one available ?
>>>
>>>
>>>
>>> I have one with low output that I would like to take a crack at fixing.
>>>
>>>
>>>
>>> Thanks, Dick, W1KSZ
---
El software de antivirus Avast ha analizado este correo electrónico en busca de virus.
https://www.avast.com/antivirus
More information about the time-nuts
mailing list