[time-nuts] Lucent RFTFm-II-XO

Bob Camp kb8tq at n1k.org
Mon Sep 5 21:20:24 EDT 2016


If you only have one box, you need to be sure the “fake” connections on the interconnect 
are correct. If they are not, you will not get it to operate correctly. 

There also is a survey process if you have not had it running in your location before. That 
could take a few hours to a few days depending on your antenna.


> On Sep 5, 2016, at 8:50 PM, Chris Waldrup <kd4pbj at gmail.com> wrote:
> Hi,
> I managed to get one of these Lucent boxes from a local ham that moved away a couple years back. 
> I finally got around to modifying it today with Skip Withrow's mod to add 10 MHz output. 
> I connected an antenna and after a few minutes the yellow and  No GPS and Fault LEDs go out and the green Online LED comes on. 
> I put my scope on both the 15 MHz out and the new 10 MHz out port and get no output. 
> Before I dig into this with my scope tomorrow night, is it as something as simple as a signal I'm missing to enable the outputs?
> I only have the antenna connected and two pins for 24 VDC, nothing else. 
> Thanks for the bandwidth. 
> Chris
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.

More information about the time-nuts mailing list