[time-nuts] Measuring coax temperature coefficient with a TICC
Mark Sims
holrum at hotmail.com
Tue Apr 18 11:50:31 EDT 2017
Unfortunately I did not have the ability to log temperature at the time I did that test. I just added support to Lady Heather for an environmental sensor so I should be able to do that later on. Currently my environmental sensor code only does two channels of temperature. I am going to build a board with an ATMEGA 328 chip and BMP280 for humidity and pressure along with support for a couple of temperature sensors (should be able to do type K thermocouples and RTD1000's)
-----------------
> maybe you can recalculate your results in PPM and plot against temperature,
to compare with the mw-journal plots?
More information about the time-nuts
mailing list