[time-nuts] TAPR Oncore M12+ kit

Dave Mallery dave.mallery at gmail.com
Sat Apr 22 15:30:24 EDT 2017


Hi Mark

I was delighted to read about Heather's ability to talk to a timing M12.  I
have been having fits here trying to get the M12 to accept any command
(using Perl.. a mistake it seems).  i wanted to end up with a Linux capable
utility and had previously used Perl to parse NEMA on my old TAC2.

I have been learning about binmode(M12) and other edge cases, but am
probably still far from the eureka moment..

anyhow, i am setting up heather5 for a trial flight.

thanks

dave mallery



On Fri, Apr 21, 2017 at 8:40 PM, Mark Sims <holrum at hotmail.com> wrote:

> Earlier somebody asked if these were M12's or M12T's.    I powered mine up
> and connected it to Lady Heather. It appears to be an M12T.   It responds
> to the survey and position hold commands and outputs the sawtooth
> correction value.     Also the hardware ID returned is P373T12T12.
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/
> mailman/listinfo/time-nuts
> and follow the instructions there.
>



-- 
Dave Mallery, K5EN                 (ubuntu linux 16-10)
PO Box 15                              Ophir,  OR  97464

      linux counter #64628 (since 1997)


More information about the time-nuts mailing list