[time-nuts] TAPR Oncore M12+ kit

[Philip Gladstone]

I was hoping that someone would design some end plates from PCBs -- it 
just needs the PCB design and then the production is easy. I've built 
cases before with PCBs as the front and rear panels -- they look nice.

I'm in for a group buy....

Philip

On 28/04/2017 08:19, Stan wrote:
> I would be interested in participating in a group buy for the end plates. I will need two of them.
>
> Regards,
> Stan
> N6BYU
>
> Date: Fri, 28 Apr 2017 09:56:55 +0100
> From: Steve - Home <steve-krull at cox.net>
> To: Discussion of precise time and frequency measurement
> 	<time-nuts at febo.com>
> Subject: Re: [time-nuts] TAPR Oncore M12+ kit
> Message-ID: <802E38FF-ADCA-435F-866D-F821C62237ED at cox.net>
> Content-Type: text/plain;	charset=us-ascii
>
> All,
>
> To add to the excellent information Art has provided - I spoke with Candice Rincon at Phoenix Mecano and just received a quote from her for the end plates. There is a $100 minimum order policy at P-M, shipping and taxes additional. The end plates with gaskets and screws are $7.25 each so we'll need to order 14 end plates to meet the minimum; that's enough to do 7 enclosures. The plates are cast aluminum and are blank so you would need to drill your own holes per the diagrams Art provided.
> I don't know how many GPS kits were sold but if there's enough interest maybe we can do a group order.
>
> Steve
> WB0DBS
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>