[time-nuts] Simple open source microcontroller solution to tune DDS needed

[paul swed]

Must have missed something here. Basic? Arduino uses C behaviors. God knows
everythings been written for it so maybe there is a basic language. That
said schematics are readily available and I believe its all open source.
Thats why its been so popular. Lots of nice simple tools for it also.
Regards
Paul
WB8TSL

On Wed, Dec 13, 2017 at 4:05 PM, Adrian Godwin <artgodwin at gmail.com> wrote:

> It's a bit bizarre that it uses Basic. I just remember my local ARC using
> it as a project sometime ago. Possibly in the 20th century. :)
>
>
> On Wed, Dec 13, 2017 at 9:03 PM, Richard (Rick) Karlquist <
> richard at karlquist.com> wrote:
>
> > This looks like a very good starting point.  It's a superset
> > that I can just simplify.
> >
> > Rick
> >
> >
> > On 12/13/2017 12:10 PM, Adrian Godwin wrote:
> >
> >> Maybe this one ?
> >>
> >> http://www.qsl.net/pa3ckr/bascom%20and%20avr/ad9951/index.html
> >>
> >> There are probably many others
> >>
> >>
> >> On Wed, Dec 13, 2017 at 8:03 PM, Richard (Rick) Karlquist <
> >> richard at karlquist.com> wrote:
> >>
> >> I need a very simple controller to tune a DDS with up/down
> >>> switches (imagine setting the time on a clock).  A DDS
> >>> chip, such as an AD9836 would go on a PC board and a couple
> >>> of pushbuttons would tell the controller to tune up or
> >>> down.
> >>>
> >>> Before reinventing this wheel, I thought I would see if
> >>> anyone knows of a similar solution that can be leveraged.
> >>> What I would like is both hardware and software, where
> >>> the software could be edited to accommodate the up/down
> >>> buttons.  A last resort would be to write software from
> >>> scratch.  My software skills are extremely limited.
> >>> Cutting and pasting code might work for me.
> >>>
> >>> I need to be able to embed this onto an existing PC board.
> >>> I can't use a preexisting "daughter" card, other than
> >>> to copy the design of the card.
> >>>
> >>> Rick Karlquist
> >>> N6RK
> >>>
> >>>
> >>>
> >>> _______________________________________________
> >>> time-nuts mailing list -- time-nuts at febo.com
> >>> To unsubscribe, go to https://www.febo.com/cgi-bin/m
> >>> ailman/listinfo/time-nuts
> >>> and follow the instructions there.
> >>>
> >>> _______________________________________________
> >> time-nuts mailing list -- time-nuts at febo.com
> >> To unsubscribe, go to https://www.febo.com/cgi-bin/m
> >> ailman/listinfo/time-nuts
> >> and follow the instructions there.
> >>
> >>
> >>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/
> mailman/listinfo/time-nuts
> and follow the instructions there.
>