[time-nuts] Optimal oscillator topology for diffrent frequency range

KA2WEU at aol.com KA2WEU at aol.com
Mon Feb 6 08:01:28 EST 2017


That is the pragmatic deflection reply ..... but essentially you are  
correct 
 
 
In a message dated 2/6/2017 7:57:26 A.M. Eastern Standard Time,  
kb8tq at n1k.org writes:

Hi

One could easily spend years answering this sort of  question. Several 
people on the 
list *have* done so. Two of them have  already tossed up answers. 

What are you trying to do?

What is  your definition of “low”? 

How well equipped are you to test this sort  of thing? 

How much tweaking are you willing to do?

Do you have  a source of (custom) low noise crystals?

Lots of questions and lots of  twists and turns in the answers as a result. 

Bob

> On Feb 6,  2017, at 4:06 AM, Yeti Yetos <rtoporowski at gmail.com> wrote:
>  
> Good morning,
> What's the optimal  oscillator topology  for low phase noise (low 
frequency
> noise and phase noise floor)  for  25Mhz/50Mhz/100Mhz frequency  range.?
> 
> Best  regards, Rafal
> _______________________________________________
>  time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to  
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the  instructions  there.

_______________________________________________
time-nuts  mailing list -- time-nuts at febo.com
To unsubscribe, go to  
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the  instructions there.


More information about the time-nuts mailing list