[time-nuts] EFOS2 MASER turns 34!
tshoppa at gmail.com
Tue Jan 3 14:15:54 EST 2017
Thanks, I will look on Tom's site for the manuals. The last time I looked
into this, I think all I saw were copper cavities.
But I think some sort of design that required very minimal machining, and
much more "plumbing", would be what I would need to do a homebrew maser :-).
On Tue, Jan 3, 2017 at 1:14 PM, <cdelect at juno.com> wrote:
> The EFOS2 uses an Aluminum cavity! So machining would be easier than
> The complete manuals with schematics are on Tom's Leapsecond.com site.
> Making a homebrew Maser was bandied about a few years ago on TimeNuts.
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/
> and follow the instructions there.
More information about the time-nuts