[time-nuts] No sat positions in LH with Trimble NTBW50AA?
keepwalking188 at ac0c.com
Thu Jan 5 13:55:19 EST 2017
I have a '50AA here. But I don't use any command line options relating to
box ID. Just start up LH - LH talks to the box, determines it's a Trimble
variant, and off to the races it goes.
From: Peter Reilley
Sent: Thursday, January 05, 2017 12:11 PM
To: Discussion of precise time and frequency measurement
Subject: Re: [time-nuts] No sat positions in LH with Trimble NTBW50AA?
I tried /rxt but that won't communicate. Must I put the unit in
Thunderbolt mode? Is there
a jumper or a command that will do it? The manual that I have does not
modes. It only talks about SCPI.
On 1/5/2017 12:41 PM, Mark Sims wrote:
> The Nortel devices can talk either as a Thunderbolt or as a SCPI device.
> Use it as a Thunderbolt (/rxt). In SCPI mode the satellite positions are
> polled for once a minute (at xx:xx:33). Thunderbolt mode provides much
> more and better control of the receiver.
>> I just got my Trimble NTBW50AA GPSDO up and running with Lady Heather
> However I don't see any satellite data as I do with my Resolution T. I
> am using
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> and follow the instructions there.
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
and follow the instructions there.
More information about the time-nuts