[time-nuts] OCXO Vectron 218Y44442
time at patoka.org
Mon Oct 16 16:10:10 EDT 2017
I am wandering if anybody observe the behavior for OCXO, when its stop
to reproduce the signal, and the only way to return it back to business
is little mechanical stress.
I have TWO of such OCXO. One of them is Austron 11.2 Mhz. And another
one is Vectron model 218Y4442 9.8304Mhz
In case with Vectron, I even disassemble it (to whom who brave here is a
Then as I connect it to the PS, I realize it start to reproduce the
signal again ! Before this it was nothing ! I tried different PS before
to open this "can" as a last resort.
For the Austron - I didn't disassemble it. Instead I just kick it a
little bit. And immediately after that, it start to produce the signal !
More information about the time-nuts