[time-nuts] Possible new run of TNS-BUF High Isolation, Low Noise Buffer Amp boards

John Ackermann N8UR jra at febo.com
Tue Jun 5 12:32:18 EDT 2018


Good news -- we had enough orders to justify doing a small production 
run of the TNS-BUF isolation amplifiers.  We'll be placing the order 
with our contract manufacturer this week, and expect delivery in six to 
eight weeks.

There will be a few extra boards available, so if you haven't ordered 
yet, there's still time.

John
----

On 05/08/2018 03:09 PM, John Ackermann N8UR wrote:
> Back in October, 2016, TAPR did a build-to-order offering of the TNS-BUF 
> low noise, high isolation buffer amplifier.  The original 2016 post is 
> attached below.  All of those units sold out, and recently I've had a 
> few questions about whether more will be available.
> 
> TAPR will do another one-off production run if we can get orders for at 
> least 25 boards (the minimum to make manufacturing viable) by *June 1*. 
> You can place an order by going to http://tapr.org/kits_tns-buf.  The 
> price will be the same as the previous production -- $119 plus shipping.
> 
> If we receive orders for at least 25 boards by June 1, we will charge 
> credit cards and place the production order with our contract 
> manufacturer.  If we don't get 25 orders, we'll cancel the project and 
> your card will not be charged.
> 
> We expect to ship finished TNS-BUF boards about 60 days after placing 
> the production order.
> 
> Best regards,
> John
> 
> -------- Forwarded Message --------
> Subject: [time-nuts] TNS-BUF High Isolation, Low Noise Buffer Amp Available
> Date: Wed, 5 Oct 2016 10:15:46 -0400
> From: John Ackermann N8UR <jra at febo.com>
> 
> I've previously mentioned a high performance buffer amplifier called the 
> "TNS-BUF" that I built based on a design by Dr. Bruce Griffiths with 
> further input from John Miles. Key numbers are:
> 
> *  Phase noise -140dBc/Hz at 1 Hertz offset, noise floor -175dBc/Hz.
>      (PN plot attached)
> *  Reverse isolation greater than 100dB; low enough that I can't make a
>      trustworthy measurement.
> *  Gain from -10 to +7 dB from 1 to 30 MHz; maximum output >18dBm.
> *  Nominal 18VDC operation, but works down to 12V with lowered
>      maximum output level.
> 
> There's information, including performance data and schematic, at
> http://www.febo.com/pages/TNS-BUF
> 
> There seems to be some interest in an amplifier like this, so TAPR has 
> decided to do a limited production run.  The amp is built with surface 
> mount parts, so we thought an assembled and tested board was better than 
> a kit.  The price will be $119 each.  But we have no idea how much 
> interest there is, and we need to build a minimum of 25 units to make 
> production feasible.
> 
> So, here's the deal:  you can order your TNS-BUF at
> 
> http://tapr.org/kits_tns-buf
> 
> through *October 20*.  If we receive orders for at least 25 boards by 
> then, we will charge credit cards and place the production order with 
> our contract manufacturer.  If we don't get 25 orders, we'll cancel the 
> project and credit cards will not be charged.  There's no guarantee that 
> boards will be available for later order.
> 
> We expect about 60 days between placing the manufacturing order and 
> receipt of the boards at TAPR.  We'll ship to customers ASAP after 
> receipt.  So that means you can expect to receive your order shortly 
> after January 1.
> 
> So, go to http://tapr.org/kits_tns-buf now to place your order before 
> the deadline!
> 
> John
> 
> 
> 
> 
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
> 


More information about the time-nuts mailing list