[time-nuts] Question about Lady Heather millisecond display
Michael Baker
mpb45 at clanbaker.org
Wed Jun 6 14:07:36 EDT 2018
Hello, Time-Nutters----
I recently updated an old version of Lady Heather that has been
running well 24/7/365 for a number of years (except during
prolonged power grid outages !). V5.0 is now installed and running.
Getting it to display full-screen takes a bit of fiddling with different
commands but otherwise seems to be running OK.
I do have a number of questions about V5.0 but one I am focusing
on at the moment is the command to enable the millisecond digits
for the time display. The info I have says this is done by entering the
/TSZ command. However, when entering this command the three
millisecond digits do appear but only alternate back and forth every
several seconds between "052" and "053". What might I be doing
wrong?
Any suggestions on how to make the millisecond digits count and
sequence correctly?
Thanks for any suggestions on resolving this issue !!
Mike Baker
Micanopy, FL
*********************
More information about the time-nuts
mailing list