[time-nuts] HP 5370B using manual start-stop

Bob kb8tq kb8tq at n1k.org
Thu May 31 09:36:47 EDT 2018


We ran 5335’s in “long gate” mode via the gate open / gate close commands. It worked, but you had to 
compensate for rollovers. My guess is that you would run into similar stuff on the 5370A. Simple answer
is to try it and see … That’s what we did on the 5335 and then worked through all the issues we found. 


> On May 30, 2018, at 11:19 PM, Perry Sandeen via time-nuts <time-nuts at febo.com> wrote:
> List,  
> I'd like to do 1000 second TIC measurements with my 5370B but I don't want to have to perchase A HP 1B prologic or similar controller for the timeing.
> As long as I'm interested in the TIC difference but not an absolute value is it reasonable to use the manual start/stop switches and a stop watch or similar timer?
> Regards,
> Perrier
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.

More information about the time-nuts mailing list