[volt-nuts] Trimming the LTZ1000 tempco
Bruce Griffiths
bruce.griffiths at xtra.co.nz
Thu Oct 6 07:12:48 UTC 2011
Andreas Jahn wrote:
>
> ----- Original Message ----- From: "m k" <m1k3k1 at hotmail.com>
> To: <volt-nuts at febo.com>
> Sent: Wednesday, October 05, 2011 8:45 PM
> Subject: Re: [volt-nuts] Trimming the LTZ1000 tempco
>
>
>>
>> Looking at the data from various manufacturers of Zeners it seems
>> that increasing the current makes the tempco become more positive.
>>
> Hi m k,
>
> But on my LTZ1000A the tempco is positive around +50 ppm/K at nominal
> current.
> So you would have to reduce the current. But this would increase noise.
>
> with best regards
>
> Andreas
>
>
Then you can easily trim the tempco as illustrated in the diagram taken
from the bottom of page 6 of the current datasheet.
Bruce
-------------- next part --------------
A non-text attachment was scrubbed...
Name: TCTrim1.png
Type: image/png
Size: 33825 bytes
Desc: not available
URL: <http://www.febo.com/pipermail/volt-nuts/attachments/20111006/c211acfb/attachment-0001.png>
More information about the volt-nuts
mailing list