[volt-nuts] Thermistor value for 732A Reference 10V Standard

[Rob Klein]

Bill,

I had to read it twice myself, but that was Mitch' point. When you want 
to check the performance
of the oven, you want to measure something that has a decent bit of 
variation over temperature.


Rob.


Op 29-6-2012 13:33, WB6BNQ schreef:
> Mitch,
>
> Quite the contrary.  The 10 volt output is the master output and therefore the
> most stable.  The others are derived from dividers and thus add additional error
> terms due to the tempco of the divider string and any possible loading presented
> to those outputs.
>
> Bill....WB6BNQ
>
> Mitch Van Ochten wrote:
>
>> I think monitoring the 1V or 1.1V is a better test over temperature than
>> monitoring the 10V.  It's quite stable even without the heater.
>>
>>