[volt-nuts] Improving Solartron 7071 and 7081

David C. Partridge david.partridge at perdrix.co.uk
Fri Feb 1 04:39:49 EST 2013


The input signal is reasonably clean.  I need to probe all the outputs of this chip I think.  It looks like this output ONLY goes to the test point, which is somewhat odd!

Regards,
David Partridge
-----Original Message-----
From: volt-nuts-bounces at febo.com [mailto:volt-nuts-bounces at febo.com] On Behalf Of m k
Sent: 01 February 2013 07:43
To: volt-nuts at febo.com
Subject: Re: [volt-nuts] Improving Solartron 7071 and 7081


Hi David,

I looks like the gate before TP3 gets a signal from off the PCB, how clean is that?  

first I would put a .1u to .22u small ceramic cap between power and ground of 403 then I would look at where TP3 signal goes to, does it feed off the PCB to anywhere else? a ring below ground means an inductive kick. HCT is even faster, so it might give a bigger kick?

Wrinkle



More information about the volt-nuts mailing list