[volt-nuts] Fluke 732A battery module (and possible circuit replacement)
Todd Micallef
tmicallef at gmail.com
Mon Aug 25 21:56:03 EDT 2014
Mark,
If you need any scans or measurements, let me know. I have one that will be disassembled for the next 24hrs. I can get this for you tomorrow evening before I replace the batteries.
Todd
Sent from my iPad
> On Aug 25, 2014, at 21:10, Mark Sims <holrum at hotmail.com> wrote:
>
> I have a 732A that is missing its battery module. Does anybody have or know of a source for a replacement?
> Also, would there be any interest in a replacement circuit assembly for the battery module? It would probably consist of a small board that plugs into the 2x6 pin edge connector and another small board with the ballast lamp/diode/resistor/thermistors and connections for the battery/switch/external power jack. The two boards would be connected by a short ribbon cable and would allow one to add batteries to a 732A that is missing the battery module. It would not be a complete battery module with the metal frame and backplate...
> _______________________________________________
> volt-nuts mailing list -- volt-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
> and follow the instructions there.
More information about the volt-nuts
mailing list