[volt-nuts] Fluke 732A battery module (and possible circuitreplacement)
Tom Miller
tmiller11147 at verizon.net
Mon Aug 25 23:32:31 EDT 2014
It might be nice to do a lithium pack including all the safety controls. The
down side is you would not be able to ship it by air.
Tom
----- Original Message -----
From: "Mark Sims" <holrum at hotmail.com>
To: <volt-nuts at febo.com>
Sent: Monday, August 25, 2014 9:10 PM
Subject: [volt-nuts] Fluke 732A battery module (and possible
circuitreplacement)
>I have a 732A that is missing its battery module. Does anybody have or
>know of a source for a replacement?
> Also, would there be any interest in a replacement circuit assembly for
> the battery module? It would probably consist of a small board that plugs
> into the 2x6 pin edge connector and another small board with the ballast
> lamp/diode/resistor/thermistors and connections for the
> battery/switch/external power jack. The two boards would be connected by
> a short ribbon cable and would allow one to add batteries to a 732A that
> is missing the battery module. It would not be a complete battery module
> with the metal frame and backplate...
> _______________________________________________
More information about the volt-nuts
mailing list