[volt-nuts] 5200a extender
DaveH
info at blackmountainforge.com
Wed Sep 24 23:00:28 EDT 2014
I know nothing of the physical dimensions needed for this but could you do a
jumper with ribbon cable to get to the other side of the connector?
Just my 2ยข
Dave
> -----Original Message-----
> From: volt-nuts [mailto:volt-nuts-bounces at febo.com] On Behalf
> Of Kgoodhew
> Sent: Wednesday, September 24, 2014 18:30
> To: volt-nuts at febo.com
> Subject: [volt-nuts] 5200a extender
>
> Hi Mark.
> I appreciate your concerns regarding the +- 300 volts
> and would be a bit worried too.
> Where is the minimal spacing you mention, is it between the
> card edge connector pads or the tracks that connect these
> pads to the ribbon cable?
> From memory the only two boards that have the +- 300 volts on
> them are the power supply and power amplifier boards, guess I
> will have to drag the manual out again and look at what is
> connected to the adjacent pins.
> Where to now?
> I have pushed my 5200a aside for the last month waiting to
> see what develops on the extender front, however I would like
> to get it going soon but I have at least one problem with the
> attenuator board which is virtually impossible to
> troubleshoot without some type of extender.
> I have managed to get hold of two 34/86 pin card edge sockets
> but I need the double sided card edge connector to go into
> the socket on the main chassis to be able to fabricate my own
> extender.
> Ken Goodhew.
>
>
> ---
> This email is free from viruses and malware because avast!
> Antivirus protection is active.
> http://www.avast.com
>
> _______________________________________________
> volt-nuts mailing list -- volt-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
> and follow the instructions there.
More information about the volt-nuts
mailing list