[volt-nuts] Current Button for Datron calibrator (4800, 4805, 4807, 4808)

[David C. Partridge]

Mark,

Yes, my fall-back position is to do a 3D design (the tricky bit will be the bit that locks onto the plunger, and the transparent circular window for the LED light).

Dave
-----Original Message-----
From: volt-nuts [mailto:volt-nuts-bounces at febo.com] On Behalf Of Mark Sims
Sent: 01 July 2017 17:30
To: volt-nuts at febo.com
Subject: [volt-nuts] Current Button for Datron calibrator (4800, 4805, 4807, 4808)

I used to make button / keytops by making a mold of a compatible one in clay or silicone rubber and filling it with epoxy followed by a lot of fiddly work carving out the interface to the keyswitch plunger.

These days 3D printers are your (frustrating) plastic pal who's fun to be with.
_______________________________________________
volt-nuts mailing list -- volt-nuts at febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
and follow the instructions there.