[volt-nuts] How can I make a 2000 V DC meter with an input resistance of at least 100 T ohms?

Dr. David Kirkby drkirkby at kirkbymicrowave.co.uk
Thu Mar 22 20:33:06 EDT 2018


I want to measure a high voltage, but put minimal load on the circuit.
Looking at the Keithley electrometers, the input resistance is at least 200
T ohms, but they tend to have a maximum of 200 V FSD.

A 2000 V source, and a 200 T ohm resistor gives a current of 10 pA, which
itself is easy to measure. But one can't buy 200 T ohm resistors. I looked
at RS in the UK, and the highest value resistor I could find is 1 T ohm,
and they are £163 each (around $200).

Maybe fabricating ones own resistor is possible, but I suspect there's a
better way. Keithely manage to keep a 200  T ohm resistance on the 200 mV
range, and there's no way that can be measured with an ammeter, which would
require an ammeter with a full scale deflection of 1 fA, which is much
smaller than the 2 pA FSD on its most sensitive range.

Any thoughts?

Dr David Kirkby Ph.D C.Eng MIET
Kirkby Microwave Ltd
Registered office: Stokes Hall Lodge, Burnham Rd, Althorne, CHELMSFORD,
Essex, CM3 6DT, United Kingdom.
Registered in England and Wales as company number 08914892
http://www.kirkbymicrowave.co.uk/
Tel 01621-680100 / +44 1621-680100


More information about the volt-nuts mailing list