[time-nuts] Fury GPDSO

ernieperes at aol.com ernieperes at aol.com
Tue Oct 30 03:44:13 EDT 2007

Hi Said,

Yes, I did removed the SMA. and the OCXO is running well from the 10.50V PCB board and the display shows all the details of the OCXO.

Cheers, Ernie.

-----Original Message-----
From: SAIDJACK at aol.com
To: time-nuts at febo.com
Sent: Tue, 30 Oct 2007 1:53 am
Subject: Re: [time-nuts] Fury GPDSO

In a message dated 10/29/2007 13:03:31 Pacific Daylight Time,  
ernieperes at aol.com writes:

>?my  board is running with this Ebay OCXO? / 320173558948 /? and this is  
pin-compatible with the >PCB.

>the first results is not bad....  compared with my HP Z3801.

Glad to hear that! Those Temex OCXO's are supposed to be pretty good in  
terms of phase noise.
Did you remove the SMA's and solder-in the OCXO?

************************************** See what's new at http://www.aol.com
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Email and AIM finally together. You've gotta check out free AOL Mail! - http://mail.aol.com

More information about the time-nuts mailing list