[time-nuts] 10 MHz Distribution Amp
EWKehren at aol.com
EWKehren at aol.com
Thu Nov 12 20:45:35 UTC 2009
Take a look at the LT 6551 it makes a good four channel distribution amp.
Bert Kehren
In a message dated 11/12/2009 3:36:04 P.M. Eastern Standard Time,
robert8rpi at yahoo.co.uk writes:
Hi,
The cheap alternative is to use a video distribution amp. Even the cheap
ones are reasonable. VGA distribution units can also be used, you get three
channels.
Robert G8RPI.
--- On Thu, 12/11/09, Richard W. Solomon <w1ksz at earthlink.net> wrote:
From: Richard W. Solomon <w1ksz at earthlink.net>
Subject: [time-nuts] 10 MHz Distribution Amp
To: time-nuts at febo.com
Date: Thursday, 12 November, 2009, 18:20
A friend of mine is looking for an inexpensive way to distribute
his 10 MHz T-Bolt signal to other instruments. The TAPR unit, while
very nice, is a tad on the pricey side when you add in the enclosure.
Any ideas what he could use that is not so expensive ?
Thanks, Dick, W1KSZ
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the time-nuts
mailing list