[time-nuts] 3048A software question

Adrian rfnuts at arcor.de
Fri Feb 17 13:06:39 UTC 2012


are you using the Opt. 311 (MS-DOS) software?
I don't know of any more recent versions.

To answer your initial question:
You can not change anything on the diagram _after_ the measurement, not 
even the title.
The spec lines will be visible only when you have defined them prior to 
starting the measurement.


SAIDJACK at aol.com schrieb:
> Hello team,
> I am trying to get an HP 3048A system up and running, and I am having
> problems with enabling spec limit lines on the graph.
> I can enter the spec line data under the "manipulate results" then "spec
> lines" menu, but the lines I entered are not visible. There are the standard
> spec lines visible when I do the internal noise floor test, so I know this
> should work.
> Does anyone know how to enable these properly? The user manual doesn't talk
>   about this, and it is written for an older version of the software
> anyway's.
> Also, I have software version A 01.01 from 1994, does anyone have any more
> recent software version?
> Thanks in advance,
> Said
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.

More information about the time-nuts mailing list