[time-nuts] Trimble SMT board
Azelio Boriani
azelio.boriani at screen.it
Mon Jun 25 12:25:27 UTC 2012
Yes, but what do you want to use instead of the PC? Nothing? A
microprocessor board? A display? The Arduino? The SMT can run alone whitout
nothing connected, except for the antenna, of course. Then you can use the
PPS, otherwise it will be very strange to let a GPS run without nothing
connected but the antenna...
On Mon, Jun 25, 2012 at 2:15 PM, Erno Peres <ernieperes at aol.com> wrote:
>
> Azelio,
>
> As I said NO any type of msg comes out from the board....only When I use
> the " TrimbleStudio SMT " software which seems to me it sending some kind
> of initialization to the board.....
>
> Rgds Ernie.
>
>
>
>
> -----Original Message-----
> From: Azelio Boriani <azelio.boriani at screen.it>
> To: Discussion of precise time and frequency measurement <
> time-nuts at febo.com>
> Sent: Mon, Jun 25, 2012 2:06 pm
> Subject: Re: [time-nuts] Trimble SMT board
>
>
> A quick look at the Trimble Resolution SMT GPS revealed that the TSIP
> acket 0x7A can manage the NMEA output: what sentences and their time
> nterval so the TrimbleStudio must have that option.
> On Mon, Jun 25, 2012 at 1:58 PM, Azelio Boriani <azelio.boriani at screen.it
> >wrote:
> > It's easy: let it run with the power on, what else? What exactly do you
> mean: no PC and what instead of the PC? Trimble products generally use the
> TSIP protocol, not a human readable one like the NMEA. Yes, the NMEA isn't
> easy to read but usually you can figure out date, time, lat/lon and 3D fix
> present or not. With the TrimbleStudio you can configure the GPS to put
> out
> the NMEA sentences (I think, I have no experience with the SMT but usually
> the GPSes from Trimble can be configured to some extent).
>
>
> On Mon, Jun 25, 2012 at 1:18 PM, Erno Peres <ernieperes at aol.com> wrote:
>
> >
> > Hi,
> >
> > anybody having some experience with this board..????
> > I have the following problem....after power on the board it does not
> > output any msg only if I use the " TrimbleStudio SMT "
> software......on
> > my PC......
> > Is there any solution to use the board without the PC/software ???????
> >
> > Thanks a lot for any usefull advise.
> >
> > Rgds Ernie.
> > _______________________________________________
> > time-nuts mailing list -- time-nuts at febo.com
> > To unsubscribe, go to
> > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> > and follow the instructions there.
> >
>
>
> ______________________________________________
> ime-nuts mailing list -- time-nuts at febo.com
> o unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> nd follow the instructions there.
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
More information about the time-nuts
mailing list