[time-nuts] Trimble SMT board

Erno Peres ernieperes at aol.com
Mon Jun 25 13:37:12 UTC 2012


Hi David,

thanks a lot for the info,.... I have also the 1PPS output, but had the impression that it will also output TSIP or any other kind of MSG upon power-up... and you can configure the board as required of the need.....it outputs  according to the TrimbleStudio SW is TEP format but any interruption of the  power / +3.3 V / then no any msg comes out..!!!!
I want to use for the Brook Shera board....so  the 1PPS is OK.
I did not chked out with the Motorola software or TAC32 but will do.

Rgds Ernie.
PS.  for what board / gpsdo / do you use  the SMT gps..????






-----Original Message-----
From: David J Taylor <david-taylor at blueyonder.co.uk>
To: time-nuts <time-nuts at febo.com>
Sent: Mon, Jun 25, 2012 2:57 pm
Subject: Re: [time-nuts] Trimble SMT board


Hi,
anybody having some experience with this board..????
 have the following problem....after power on the board it  does not output 
ny msg only if I use the  " TrimbleStudio SMT "  software......on my 
C......
s there any solution to use the board without the PC/software ???????
Thanks a lot for any usefull advise.
Rgds Ernie.
______________________________________________

rnie,
I have one of these boards, and when I powered it up I got locked PPS 
ignals (albeit, quite narrow width).  I didn't need to use any PC software 
or this - no configuration was required.  If you look back on the mailing 
ist messages, you may find a mention that the units recently on sale use a 
otorola protocol, not the Trimble protocol.
Cheers,
avid
- 
atSignal Software - Quality software written to your requirements
eb: http://www.satsignal.eu
mail: david-taylor at blueyonder.co.uk 

______________________________________________
ime-nuts mailing list -- time-nuts at febo.com
o unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
nd follow the instructions there.



More information about the time-nuts mailing list