[time-nuts] OT Prototype Boards
Brent Gordon
time-nuts at adobe-labs.com
Tue Jun 25 10:40:53 EDT 2013
I once saw a board that was 2.5 mm, which would cause what you
describe. As soon as I figured out what the problem was, in the trash
it went.
Brent
On 6/25/2013 8:03 AM, Bob Stewart wrote:
> OK, I see in the wiki that 0.1" is by definition 2.54mm. I was taught it was 2.54001, but that's not right, either. But, if industry says that they're defined as the same, then I'm the one out of date. =) I wonder what was with that old prototype board. I can't find it, so it must be in a landfill, but it was just exactly the wrong size to fit a chip. You could get the first few pins in, but then the differences would be enough that no more would fit.
>
> Bob
>
More information about the time-nuts
mailing list