[time-nuts] Z3815A show 0ns Predicted uncertainty

[Bob Camp]

Hi

The holdover prediction is entirely dependent on the OCXO and how it's behaving. Your OCXO likely had a pair of events that caused the aging estimate to get very low.

Bob

On Jun 28, 2013, at 8:16 AM, Mark C. Stephens <marks at non-stop.com.au> wrote:

> I noticed my Z3815A was show 0ns (zero) for predicted uncertainty tonight.
> 
> Is there something wrong or is its predicted holdover uncertainty below measureable (displayable) value?
> Is there a pForth command that would give me an accurate figure for PHU?
> My 5 other Z3805A smartclocks are all in the 100-800ns range as well so I am not sure what's going on up there.
> New birds?
> 
> -marki
> 
> 
> 
> Kind Regards,
> Mark Stephens
> 
> Mark Clemens Stephens | Customer service engineer | Non-Stop Computer Ltd
> * +61 2 9011 8186 | ( +61 428 256 334 | * marks at non-stop.com.au<mailto:marks at non-stop.com.au>
> 
> Non-Stop Computer PTY LTD
> 79 Devon St
> North Epping
> NSW 2121
> Australia
> Timezone: AEST (UTC +10)
> 
> Email: service at non-stop.com.au<mailto:service at non-stop.com.au>
> 
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.