[time-nuts] Lucent KS-24361 15 Mhz and 10 Mhz

[Dr. David Kirkby (Kirkby Microwave Ltd)]

On 1 Dec 2014 03:35, "paul swed" <paulswedb at gmail.com> wrote:
>
> OK so it was not as hard as I thought getting all of teh screws out. The
> harder part is getting the actual board to slip out of the back.
> After getting to the bottom I found a locked 10 Mhz signal on U206 pin 1
> somewhat of a sine wave

Why do you need to do this?  The picture I see on eBay shows an SMA
connector with "10 MHz TP" on it. I assumed that was a 10 MHz output, but I
assume that there's a good reason you are doing this.

Dave