[time-nuts] TU60-D120-041 power up

[Michael Jensen]

Jerry it transmit navmann binary protecol and the 1 Sec puls come on almost
after power on but it produce this pulse both with or without sattlites
received, I can mail you a small program which program it to transmit NMEA
format, it does not keep this infor when powered off.

Michael, OZ2ELA

-----Oprindelig meddelelse-----
Fra: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] På vegne
af Jerry
Sendt: 23. juni 2014 05:53
Til: time-nuts at febo.com
Emne: [time-nuts] TU60-D120-041 power up

I bought a receiver labelled as Conexant Jupiter-T TU60-D120-041.  I
constructed an RS-232 serial interface, a 1 Pulse per Second LED and a
10 kHz test point.  After a few minutes the 1 pulse per second LED syncs up
with the audible ticks on WWV so it seems that the receiver is receiving the
satellites in some fashion.

I would like to monitor the satellite and receiver status using WinLabMon or
something like it.  At power up I see a single 14 msec burst of data coming
out of the receiver serial port but I have no idea what that data says.

Is that the default power up state, just a single burst of data?

What should I be doing to get meaningful data out of the receiver into the
computer?

Thank you,  Jerry
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.