[time-nuts] 3.0GHz Channel 3 installation in Agilent 53132A counter

Brian Inglis Brian.Inglis at SystematicSw.ab.ca
Tue Mar 18 15:32:17 EDT 2014

On 2014-03-18 12:19, James Robbins wrote:
> I hope this is not too OT.
> I have acquired a 3.0GHz original Channel 3 board for my Agilent 53132A
> counter.  When installed, it reads four times (4x) the actual frequency.
> I'm wondering if anyone has any experience with such an installation and can
> point me to some setup item or zero ohm resistor I'm supposed to install.
> All that the manual says is to have it done by the factory.  That will cost
> me more than the board itself.  Many thanks.
> Jim Robbins
> N1JR

According to:
early serial numbers may need updated firmware.

Take care. Thanks, Brian Inglis

More information about the time-nuts mailing list