[time-nuts] Z3812 Diag port data? RE: time-nuts Digest, Vol 124, Issue 26

[Tom Miller]

If they are straight wired pin 1 to pin 1, pin 2 to pin 2, etc, they will 
not work.


----- Original Message ----- 
From: "Don Latham" <djl at montana.com>
To: "Discussion of precise time and frequency measurement" 
<time-nuts at febo.com>
Sent: Tuesday, November 04, 2014 1:23 AM
Subject: Re: [time-nuts] Z3812 Diag port data? RE: time-nuts Digest, Vol 
124, Issue 26


> Bob and all: Haven't hookedd upmy units yet. Marlon P Jones (MPJA) has 
> some
> Real Cheap 15 pin m-m cables that are 1 ft long, might be useful. no 
> clipped
> pins, whatever they're for. I don't think many of us want to hot-plug that
> cable?
> Don
>
> Bob Camp
>>
>> My boxes were flakey at first. What I finally figured out was that the
>> interface cable was the weak link. I’d bet that the short pins don’t mate
>> quite well enough with their sockets. After some wiggling all has been ok 
>> for
>> a while.
>>
>
> -- 
> "The power of accurate observation is commonly called cynicism by those 
> who
> have not got it."
> -George Bernard Shaw
>
> Dr. Don Latham AJ7LL
> Six Mile Systems LLC
> 17850 Six Mile Road
> Huson, MT, 59846
> mail:  POBox 404
> Frenchtown MT 59834-0404
> VOX 406-626-4304
> Skype: buffler2
> www.lightningforensics.com
> www.sixmilesystems.com
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to 
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.