[time-nuts] Lucent KS-24361 24V DC power requirements

Azelio Boriani azelio.boriani at gmail.com
Fri Nov 21 12:45:24 EST 2014

At most you need 2.4A (when the two OCXOs are heating up): a 2.5A
supply is needed.

On Fri, Nov 21, 2014 at 6:25 PM,  <planophore at aei.ca> wrote:
> Good day all,
> I have been following the discussions as best as I could. I recell seeing
> the question asked or at least theorized as to what is the power
> requirements of these units - either individually or together.
> I have reviewed all messages or at least all that I can find in these
> threads but I couldn't find a definitive answer unless of course the
> answer is in one of the responses hiding where I haven't looked.
> I purchased a set of these modules and they are currently in transit but
> I don't have a 24V DC supply at the moment.
> So, in order to try and get ahead before the arrival of these modules I
> would like to at least plan out if not get a suitable power supply
> ready. I don't want to over specify by too much and worse yet, under
> specify.
> Has anyone actually made any power used measurements of these modules? 2A
> average, 4A peak? Somewhere inbetween or more?
> cheers, Graham ve3gtc
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.

More information about the time-nuts mailing list