[time-nuts] Lucent KS-24361 24V DC power requirements

[Neil Schroeder]

I drive my prs10 with a parallel pair of ldos balanced by an op amp. I'll
draw it out and post it if you like.

On Friday, November 21, 2014, Azelio Boriani <azelio.boriani at gmail.com>
wrote:

> At most you need 2.4A (when the two OCXOs are heating up): a 2.5A
> supply is needed.
>
> On Fri, Nov 21, 2014 at 6:25 PM,  <planophore at aei.ca <javascript:;>>
> wrote:
> > Good day all,
> >
> > I have been following the discussions as best as I could. I recell seeing
> > the question asked or at least theorized as to what is the power
> > requirements of these units - either individually or together.
> >
> > I have reviewed all messages or at least all that I can find in these
> > threads but I couldn't find a definitive answer unless of course the
> > answer is in one of the responses hiding where I haven't looked.
> >
> > I purchased a set of these modules and they are currently in transit but
> > I don't have a 24V DC supply at the moment.
> >
> > So, in order to try and get ahead before the arrival of these modules I
> > would like to at least plan out if not get a suitable power supply
> > ready. I don't want to over specify by too much and worse yet, under
> > specify.
> >
> > Has anyone actually made any power used measurements of these modules? 2A
> > average, 4A peak? Somewhere inbetween or more?
> >
> > cheers, Graham ve3gtc
> > _______________________________________________
> > time-nuts mailing list -- time-nuts at febo.com <javascript:;>
> > To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> > and follow the instructions there.
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com <javascript:;>
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>