[time-nuts] HP10811-60212-B Pinouts.

John Miles john at miles.io
Fri Oct 10 19:58:24 EDT 2014

I'm not familiar with the 10811-60212 variant, but I have a -60168 single oven part whose 6-pin connector is wired like this:

BLK  	Gnd
RED  	Oscillator power +11.5-13V
BLK 	Gnd
YEL 	Oven monitor
GRN 	Oven power +20-30V
BLU 	Oven ground

The coax connectors are probably SMB (J1=EFC, J2=10 MHz out).

Schematics will be comparable to the rest of the 10811 series, as seen in http://www.leapsecond.com/museum/10811a/10811a.pdf .  

The red and gray wires probably go to the outer oven and its associated thermistor, if the -60212 is a DOCXO.  Sounds like it is from what you're saying.  No guarantee that the pinout above will work with your oscillator, so use caution when powering it up for the first time.

-- john, KE5FX
Miles Design LLC

> -----Original Message-----
> From: time-nuts [mailto:time-nuts-bounces at febo.com] On Behalf Of
> dan at irtelemetrics.com
> Sent: Friday, October 10, 2014 4:32 PM
> To: time-nuts at febo.com
> Subject: [time-nuts] HP10811-60212-B Pinouts.
> Hi All,
> I recently picked up an HP10811-60212-B oscillator. However I don't
> happen to have the pinouts for this device.

More information about the time-nuts mailing list