[time-nuts] Mechanical 1PPS Oscillator Disciplining

Alan Melia alan.melia at btinternet.com
Sat Jan 10 08:37:06 EST 2015


Hi David yes I think I have seen similar but not as low as that. If you 
compare the suspension points the different vibrational mode should 
obvious.....the suspension point is at a node. I think some of these are 
quite difficult to excite, I have not seen any suggested circuits but I have 
not looked too hard.

Alan
----- Original Message ----- 
From: "David J Taylor" <david-taylor at blueyonder.co.uk>
To: "Discussion of precise time and frequency measurement" 
<time-nuts at febo.com>
Sent: Saturday, January 10, 2015 7:06 AM
Subject: Re: [time-nuts] Mechanical 1PPS Oscillator Disciplining


> Hi Tom dividing down wasn't always necessary I have sample from the UK 
> GPO
> Crystal Factory of NT-cut bars, quartz tuning fork, and Gapped Ring
> crystals, the latter marked 400cps (pre Hertz :-))  )  I think these are
> post WWII because they are mounted in IO base GT style tube envelopes.
> Dividers were achieved with neons and locked multivibrators, where
> necessary, I believe.
> []
> Alan
> G3NYK
> ================================
>
> I have one "500 c/s" GEC crystal in an octal base which is thinner than a 
> "60 Kc/s" one, so a different mode.  Never had it working, though.
>
> 73,
> David GM8ARV
> -- 
> SatSignal Software - Quality software written to your requirements
> Web: http://www.satsignal.eu
> Email: david-taylor at blueyonder.co.uk
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to 
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there. 



More information about the time-nuts mailing list