[time-nuts] Safely getting the electrical length of a connected antenna feedline

Chris Albertson albertson.chris at gmail.com
Tue Aug 9 15:48:06 EDT 2016

On Tue, Aug 9, 2016 at 9:10 AM, Bob Albert via time-nuts
<time-nuts at febo.com> wrote:
> Yes, a board with the required footprint would be the way to go.  Where does one find that?

You can have small PCBs made for $3 each.
There are places here in the US that will do PCBs for $3/square inch
with a one square inch minimum.   basicpcb.com sone of these.

It is not hard to design a basic "carrier board" that has just one
chip's footprint and maybe a decoupling capacitor and a 0.1" header
connector.   Many times the chip's data sheet will have an example PCB
layout you can borrow that will fit in a one square inch board.


Chris Albertson
Redondo Beach, California

More information about the time-nuts mailing list